ChipFind - документация

Электронный компонент: P500-37DC

Скачать:  PDF   ZIP
(Preliminary)
PLL500-37
Low Phase Noise VCXO (36MHz to 130MHz)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 03/01/06 Page 1
FEATURES
VCXO output for the 36MHz to 130MHz range
Low phase noise (-148 dBc @ 10kHz offset at
77.76MHz).
CMOS output with OE tri-state control.
36 to 130MHz fundamental crystal input.
Integrated high linearity variable capacitors.
8mA drive capability at TTL output.
+/- 150 ppm pull range, max 5% linearity.
Low jitter (RMS): 2.5ps period jitter.
Single 2.5V 10% or 3.3V 10 power supply.
Operating temperature range from -40C to +85C
Available in Die or Wafer form.
DESCRIPTION
The PLL500-37 is a low cost, high performance and
low phase noise VCXO for the 36 to 130MHz range,
providing less than -148dBc at 10kHz offset at
77.76MHz. The very low jitter (2.5 ps RMS period
jitter) makes this chip ideal for applications requiring
voltage controlled frequency sources. Input crystal
can range from 36 to 130MHz (fundamental resonant
mode).

PIN AND PAD CONFIGURATION






Note: ^ denotes pull-up resistor
DIE SPECIFICATIONS
Name Value
Size
39 x 32 mil
Reverse side
GND
Pad dimensions
80 micron x 80 micron
Thickness 12
mil







BLOCK DIAGRAM
XTAL
OSC
OE
XIN
XOUT
VCON
VARICAP
5
Y
X
(0,0)
(812,986)
39 mi
l
32 mil
8
6
2
3
4
7
1 XIN
OE^
CLK
GND
VCON
XOUT
OE^
VDD
(Preliminary)
PLL500-37
Low Phase Noise VCXO (36MHz to 130MHz)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 03/01/06 Page 2
PAD ASSIGNMENT AND DESCRIPTION
Die Pad Position
Name Pad
#
X (
m) Y
(
m)
Type Description
XIN
1
94.2
768.6
I
Crystal input pin.
2 94.2
605.0
OE
7 715.5
626.7
P
Output Enable input pin. Disables the output when low.
Internal pull-up enables output by default if pin is not
connected to low. Use only one OE signal.
VCON
3
94.2
331.7
I
Frequency control voltage input pin.
GND 4 94.2
140.4
P
Ground
pin.
CLK
5
715.5
203.9
O
Output clock pin.
VDD
6
715.5
455.7
P
VDD power supply pin.
XOUT 8 477.0
888.8
O
Crystal
output
pin.
ELECTRICAL SPECIFICATIONS
1. Absolute Maximum Ratings
PARAMETERS SYMBOL
MIN.
MAX.
UNITS
Supply Voltage
V
DD
4.6 V
Input Voltage, dc
V
I
-0.5
V
DD
+0.5 V
Output Voltage, dc
V
O
-0.5
V
DD
+0.5 V
Storage Temperature
T
S
-65 150
C
Ambient Operating Temperature*
T
A
-40 85
C
Junction Temperature
T
J
125
C
Lead Temperature (soldering, 10s)
260
C
ESD Protection, Human Body Model
2
kV
Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permanent damage to the
device and affect product reliability. These conditions represent a stress rating only, and functional operations of the device at these or any other con-
ditions above the operational limits noted in this specification is not implied.
* Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade only.
(Preliminary)
PLL500-37
Low Phase Noise VCXO (36MHz to 130MHz)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 03/01/06 Page 3
2. AC Electrical Specifications
PARAMETERS SYMBOL CONDITIONS MIN.
TYP.
MAX.
UNITS
Input Crystal Frequency
36
130
MHz
0.8V ~ 2.0V with 10 pF load
1.15
Output Clock Rise/Fall Time
0.3V ~ 3.0V with 15 pF load
3.7
ns
Output Clock Duty Cycle
Measured @ 1.4V
45
50
55
%
Short Circuit Current
50
mA

3. DC Specifications
PARAMETERS SYMBOL
CONDITIONS
MIN. TYP. MAX.
UNITS
Supply Current, Dynamic,
with Loaded Outputs
I
DD
F
XIN
= 77.76MHz
Output load of 15pF
7.2 9
mA
Allowable output load ca-
pacitance
C
L
(Output)
Standard drive up to 100MHz
15
pF
Operating Voltage
V
DD
2.25 3.63
V
Output Low Voltage at
CMOS level
V
OLC
I
OL
= +4mA
0.4
V
Output High Voltage at
CMOS level
V
OHC
I
OH
= -4mA
V
DD
0.4
V
Output drive current
For V
OL
<0.4V or V
OH
>2.4V 8
mA
Short Circuit Current
50
mA
VCXO Control Voltage
VCON
0
V
DD
V
4. Voltage Control Crystal Oscillator
PARAMETERS SYMBOL CONDITIONS MIN.
TYP.
MAX.
UNITS
VCXO Stabilization Time *
T
VCXOSTB
From power valid
10
ms
VCXO Tuning Range
F
XIN
= 36 130MHz;
XTAL C
0
/C
1
< 250
0V
VCON 3.3V
300 ppm
CLK output pullability
VCON=1.65V,
1.65V
150
ppm
VCXO Tuning Characteristic
100 ppm/V
Pull range linearity
5
%
Power Supply Rejection
PWSRR
Frequency change with
VDD varied +/- 10%
-1 +1
ppm
VCON pin input impedance
2000
k
VCON modulation BW
0V
VCON 3.3V, -3dB
45 kHz
Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits.
(Preliminary)
PLL500-37
Low Phase Noise VCXO (36MHz to 130MHz)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 03/01/06 Page 4
5. Crystal Specifications
PARAMETERS SYMBOL CONDITIONS MIN.
TYP.
MAX.
UNITS
Crystal Resonator Frequency
F
XIN
36 130
MHz
Crystal Loading Rating
C
L (xtal)
VCON = 1.65V
5.0 pF
Maximum Sustainable Drive Level
200
W
Operating Drive Level
50
W
C0/C1
250 -
C0 2.0pF, F
XIN
up to 85MHz
C0 2.5pF, F
XIN
up to 80MHz
C0 3.0pF, F
XIN
up to 75MHz
30
C0 2.0pF, F
XIN
up to 95MHz
C0 2.5pF, F
XIN
up to 90MHz
C0 3.0pF, F
XIN
up to 85MHz
25
C0 2.0pF, F
XIN
up to 110MHz
C0 2.5pF, F
XIN
up to 105MHz
C0 3.0pF, F
XIN
up to 100MHz
20
ESR R
S
C0 2.0pF, F
XIN
up to 130MHz
C0 2.5pF, F
XIN
up to 120MHz
C0 3.0pF, F
XIN
up to 115MHz
15
Note: The crystal must be such that it oscillates (parallel resonant) at nominal frequency when presented a C Load as specified above.
If the crystal requires more load to be at nominal frequency, the additional load must be added externally.
This however may reduce the pull range and oscillator gain.

6. Jitter and Phase Noise Specifications
PARAMETERS CONDITIONS
MIN.
TYP.
MAX.
UNITS
RMS Period Jitter
(1 sigma 1000 samples)
With capacitive decoupling between
VDD and GND.
2.5 ps
Phase Noise relative to carrier
77.76MHz @10Hz offset
-80
dBc/Hz
Phase Noise relative to carrier
77.76MHz @100Hz offset
-110
dBc/Hz
Phase Noise relative to carrier
77.76MHz @1kHz offset
-134
dBc/Hz
Phase Noise relative to carrier
77.76MHz @10kHz offset
-148
dBc/Hz
Phase Noise relative to carrier
77.76MHz @100kHz offset
-150
dBc/Hz
Phase Noise relative to carrier
77.76MHz @1MHz offset
-152
dBc/Hz
(Preliminary)
PLL500-37
Low Phase Noise VCXO (36MHz to 130MHz)
47745 Fremont Blvd., Fremont, California 94538 Tel (510) 492-0990 Fax (510) 492-0991 www.phaselink.com Rev 03/01/06 Page 5
ORDERING INFORMATION

PhaseLink Corporation, reserves the right to make changes in its products or specifications, or both at any time without notice. The information fur-
nished by Phaselink is believed to be accurate and reliable. However, PhaseLink makes no guarantee or warranty concerning the accuracy of said
information and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product.
LIFE SUPPORT POLICY: PhaseLink's products are not authorized for use as critical components in life support devices or systems without the ex-
press written approval of the President of PhaseLink Corporation.
For part ordering, please contact our Sales Department:
47745 Fremont Blvd., Fremont, CA 94538, USA
Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
The order number for this device is a combination of the following:
Device number, Package type and Operating temperature range
PLL500-37 X X
PART NUMBER
TEMPERATURE
C=COMMERCIAL
I=INDUSTRIAL
PACKAGE TYPE
W= Wafer
D= DIE

Part / Order Number
Marking
Package Option
PLL500-37WC
P500-37WC Wafer
PLL500-37DC
P500-37DC
Die (Waffle Pack)